GRATE FYRES - Gas coal effect fires T: 01243 376825 E: Info@gratefyres.com

If you do not have a chimney in your home then one of these powered flue options could be the answer.
Integral Powered Flue 16" VFC Convector

Specially developed for cavity wall properties, this 16" VFC Convector Fire has been designed to use the gap in the cavity to save space in your room. It also has totally integrated electronics and safety features for ease of installation and operation. All you need is a room with an outside cavity wall and to be able to position the fire so that the flue can go staright through.

Integral Powered Flue Convector Fire
(8432) with optional brass frame (8453) and spanish brass front (8338)

Applications

Properties with no chimney

Installation requirements

Cavity wall outside of building

Maximum wall thickness, including any marble slips, surrounds, back panels etc is 19 5/8" (500mm)
Minimum is 12" (300mm)

if inner wall removed it is liekly a lintel will be required

Mains electricity supply via a fused spur as well as gas

Flue run must be horizontal

There are specific requiremnets for the siting of extractor units, refer to installer for more details

Wall or floor vent necessary

Choices to be made

1. Natural Gad or LPG
2. Consider optional brass frame (8453)
3. Choose 16" front from selection

fire fronts
4. If to be installed with Stovax Classic Fireplace, select 8433C or P8432C which includes wall switch
5. If P8432 or P8432C select air vent

air vent
6. If extractor unit is sited less than 6' 6" (2m) from ground, select terminal guard (8454)

The Powered Flue's extractor unit is neat, weatherproof and measures 11' x 11' x 8 1/2" deep (280x280x215mm) If mounted less than 6' 6" (2m) from the ground a Terminal Guard (8454) will be required

If you do not have a conventional chimney, wish to position your fire against an inside wall or would prefer an 18" or 22" fire, there is is still an excellent chance that a VFC Convector can be fitted in your home using the Gazco Powered Flue Kit (8435). The essential requiremnets are that the fire can be installed within 19' 6" (6m) of an outside wall, the extractor unit more than 1' (300mm) from a window and you have space in the room to construct a 11" (280mm) deep stud-work chimney breast.

Diagrammatic representation only. Not accurate for installation purposes.
	Applications

	Properties with no chimney
	Installation requirements

	Fires must be fitted within 19' 6" (6m) of an outside wall with no more than one bend of 90 degrees in the 5" diameter flue (or deduct 1m for each additional bend up to a maxmum of 4 bends on 2m of flue) There are specific requirements for the siting of extarctor units, refer to installer for more details Main electricity supply via a fused spur as well as gas Stud-work chimney breast 11" (280mm) deep will probably be required
	Choices to be made

	1. Select options appropriate to type of VFC Convector Fire you require 2. Decide on flue route and then select top adapter (8449) or rear adaptor (8448) 3. If extractor unit is sited less than 6' 6" (2m) from ground, select terminal guard (8454)